Rastergraf Eclipse3 Series Manual de usuario descargar pdf (Pagina 41)

Rastergraf

Installing Your Peritek Graphics Board 2-9

Figure 2-4 Installation of the PMC Module into an Emerson CPV3060

4. Touch a metal part of the computer chassis, remove the graphics board

from its anti static bag, and immediately slip it into the slot. After

ensuring that the board is seated correctly, install the mounting screws

(two near the front and two near the PMC connectors).

Note

Sometimes the graphics board front panel can hang up going into the

carrier front panel hole. This can be because there is a little rubber EMI

gasket that is installed in a slot cut into the graphics board front panel. If

the hole in the carrier board is “on the small side” it can be difficult if not

impossible to install the graphics board. In this case, you will have to

remove and discard the gasket.

5. Close the computer.

Now, go to Section 2.7.

1 2 ... 36 37 38 39 40 41 42 43 44 45 46 ... 84 85

Sin comentarios

Rastergraf Eclipse3 Series Manual de usuario Pagina 41